Homebrew CLI

harbor-rs brew bump renders a Homebrew formula from release metadata and archive files that already exist on disk. It computes sha256 sums from the local archive paths and writes a ready-to-commit formula to a tap repository.

The archive URL is embedded in the formula, while the archive path is only used for hashing. The URL must point at the same bytes as the local path; otherwise brew install will fail with a checksum mismatch.

Example

harbor-rs brew bump \
  --tap ../homebrew-tap \
  --name my-app \
  --version 1.0.0 \
  --description "My example application" \
  --homepage https://example.com/my-app \
  --license MIT \
  --depends openssl@3 \
  --binary my-app \
  --archive darwin_arm=https://example.com/releases/my-app-1.0.0-aarch64-darwin.tar.gz,dist/my-app-darwin-arm.tar.gz \
  --archive linux_intel=https://example.com/releases/my-app-1.0.0-x86_64-linux.tar.gz,dist/my-app-linux-intel.tar.gz

Use --stdout instead of --tap to print the formula for review or piping:

harbor-rs brew bump --stdout \
  --name my-app \
  --version 1.0.0 \
  --description "My example application" \
  --homepage https://example.com/my-app \
  --license MIT \
  --archive linux_intel=https://example.com/my-app.tar.gz,dist/my-app.tar.gz

Use --push to run git add, git commit, and git push in the tap repository. This mode is default-off, requires --tap, and aborts if the tap has dirty files other than Formula/<name>.rb. Git credentials are the caller’s responsibility.